Regulator Rectifier 0585001 0584476 for OMC Johnson Evinrude 40 50 60 70 HP Outboard 18-5827
Regulator Rectifier 0585001 0584476 for OMC Johnson Evinrude 40 50 60 70 HP Outboard 18-5827
Product Overview
Regulator rectifier, a direct replacement part for OMC Johnson and Evinrude 40 HP, 50 HP, 60 HP and 70 HP outboards built from 1992 onwards. It replaces Johnson and Evinrude 0585001, 0584476 and 0777676, CDI Electronics 193-4476 and Sierra 18-5827. The unit measures 107 mm long by 50 mm wide and weighs 387 g with its packaging.
This is the part that turns the stator output into charging current and holds it at battery voltage. When it fails, the motor still starts and runs, but the battery goes flat between trips, or the tachometer stops reading.
The 40 HP and 50 HP motors use two or three cylinders depending on the year, and the 60 HP and 70 HP are three cylinder motors. All four take the same regulator, which is why one part number covers the whole 40 HP to 70 HP range.
Fitment runs by model code and year. Check the code on your motor against the table before you order, because the same horsepower was sold under several model designations.
Specifications
| Specification | Detail |
|---|---|
| Condition | New / New with tags |
| Type | Regulator rectifier assembly |
| Johnson And Evinrude Part Numbers | 0585001, 0584476, 0777676 |
| CDI Electronics Cross Reference | 193-4476 |
| Sierra Cross Reference | 18-5827 |
| Fits | OMC Johnson and Evinrude 40 HP to 70 HP outboards |
| Cylinders | 2 and 3 cylinder models |
| Years | 1992 to 2008, by model |
| Length | 107 mm / 4.21 in |
| Width | 50 mm / 1.97 in |
| Package Contents | 1 x regulator rectifier |
| Country of Origin | Taiwan |
| Net Weight | 387 g including packaging |
| Pack Size | 145 mm x 85 mm x 105 mm |
| Pack Size In Inches | 5.71 in x 3.35 in x 4.13 in |
| Warranty | 3 year |
OEM Cross Reference
| Brand | Part Numbers |
|---|---|
| Johnson | 0585001, 0584476, 0777676 |
| Evinrude | 0585001, 0584476, 0777676 |
| CDI Electronics | 193-4476 |
| Sierra | 18-5827 |
Compatible Engines
| Model | Horsepower | Years | Cylinders |
|---|---|---|---|
| Johnson and Evinrude | 60 HP | 1992 to 2001 | 3 |
| Johnson and Evinrude | 70 HP | 1992 to 2001 | 3 |
| Johnson and Evinrude | 50 HP | 1992 to 2005 | 2 and 3 |
| Johnson and Evinrude | 40 HP | 1992 to 2008 | 2 and 3 |
Model Codes Covered
| Horsepower | Model Designations |
|---|---|
| 60 HP | Te, Ttl, J, El, Tl, Jpl |
| 60 HP | Te, J, Ei, Tl, Ttl, El, Tll, Dt, Jl |
| 70 HP | El, Tl, Tx, Ttl, Dt, Jl |
| 70 HP | El, Tl, Tx, Ttl, Ttl, C, S, Dt, Jl, Rnlb |
| 50 HP | El, Tl, Tx, Ttl, Dt, Jl |
| 50 HP | Te, Ttl, J, El, Tl, Jpl |
| 40 HP | Te, Ttl, J, El, Tl, Jpl |
What's Included
| Component | Detail | Qty |
|---|---|---|
| Regulator rectifier | Complete unit, direct fit | 1 |
| Stator | Not included | 0 |
| Flywheel | Not included | 0 |
| Mounting bolts | Not included, reuse the originals | 0 |
Signs The Regulator Has Failed
| What You See | What It Means | What To Do |
|---|---|---|
| Battery flat after a few trips | No charging output | Fit the new regulator |
| Tachometer stopped reading | Regulator supplies the tacho signal | Fit the new regulator |
| Battery boiled dry | Regulator passing full stator voltage | Fit the new regulator |
| Lights brighten with engine speed | No voltage control | Fit the new regulator |
| Charging fuse blows repeatedly | Shorted output stage | Fit the new regulator |
| Motor runs fine but will not charge | Rectifier diodes open | Fit the new regulator |
Fitting Notes
| Step | Action |
|---|---|
| 1 | Read the model code and year off the motor and check the tables above |
| 2 | Disconnect the battery before touching the charging circuit |
| 3 | Unplug the stator leads and the battery lead from the old unit |
| 4 | Check the stator resistance before fitting, a bad stator kills the new regulator |
| 5 | Bolt the new regulator to clean metal so it has a good earth |
| 6 | Reconnect the stator and battery leads to the matching terminals |
| 7 | Start the motor and check battery voltage rises to about 14 volts at fast idle |
| 8 | Check the tachometer reads again and stop if the voltage keeps climbing |
Condition & Warranty
| Item | Detail |
|---|---|
| Condition | New / New with tags |
| Warranty | 3 year |
| Packaging | Sealed retail packaging |
Before You Buy
- Fits OMC Johnson and Evinrude 60 HP and 70 HP three cylinder motors from 1992 to 2001
- Fits OMC Johnson and Evinrude 50 HP two and three cylinder motors from 1992 to 2005
- Fits OMC Johnson and Evinrude 40 HP two and three cylinder motors from 1992 to 2008
- Replaces Johnson and Evinrude 0585001, 0584476 and 0777676
- Crosses to CDI Electronics 193-4476 and Sierra 18-5827
- Unit is 107 mm long and 50 mm wide
- 387 g with packaging, box 145 mm x 85 mm x 105 mm
- 30-Day Easy Returns
Verfügbarkeit für Abholungen konnte nicht geladen werden
Boat Owners' Review
Before You Buy
Frequently Asked Questions
What is your refund policy?
We offer a 14-day hassle-free return on all products. Items must be unused and in original packaging. Every XRmarine part is also covered by our 1-year warranty against manufacturing defects. If something is not right, email us at info@xrmarineparts.com — replacement or full refund, your choice.
See our full Refund Policy for complete details.
How does shipping work?
Free international shipping on every order — no minimums. We operate a global warehouse network with a main distribution centre in Asia (10-20 business days). We also hold stock in regional warehouses across the United States, Germany, the United Kingdom, Australia, and Poland (opening soon) — most orders arrive in 1-3 business days within those countries and in 2-8 business days to nearby regions. Tracking included.
See our full Shipping Policy.
How do you keep prices fair?
We cut out the middlemen. XRmarine sources directly from quality manufacturers and sells at honest prices. Same OEM-quality parts, no dealership markup. Every order comes with free shipping, real expert support, and a 1-year warranty.
Learn more on our About Us page.
What payment methods do you accept?
We currently accept PayPal — a fast, secure way to pay online. Credit card payments (Visa, Mastercard, American Express) and Shopify Payments are being set up and will be available soon. We appreciate your patience.